Objet Objet30 User Manual - page 114
Manual is about: 3-D Printer System
of
142
Operating & Maintaining the Objet30 3-D Printer
7–34
DOC-24000 Rev. C
14. In the final wizard screen, choose to either repeat the head alignment
procedure or close the wizard.
•
If the most closely aligned vertical lines for a print head were at
either extreme, choose Yes to run the head‐alignment wizard again,
then click
Next
.
The transparency test will show if the heads are now properly
aligned, and—if not—the wizard will allow you to “fine tune” the
alignment.
•
If the vertical lines for the print heads were not aligned at either
extreme, choose No to close the wizard, then click
Next
.
Figure 7-49: Final wizard screen