Objet Objet30 User Manual - page 38
Using Objet Studio
5–4
DOC-24000 Rev. C
If the Preview check box is selected, the object is displayed in the dialog
box, as shown in figure 5‐4.
5. Select any of the following options, as required:
•
Units
—Choose millimeters or inches for the object’s units of measure.
•
Number of copies
—Choose how many copies of this object to place
on the build tray.
•
Arrange models
—Select this check box to automatically position
objects on the build tray for efficient model building.
Note: The 3-D file contains the object's proportions, but not its units of
measure. Therefore, make sure to correctly select either millimeters or
inches when inserting an object. Otherwise, the size of the object on the
build tray will be either much too large or much too small.
6. Click
Open
.
Objet Studio places the object on the build tray, and in the list in the
hierarchy pane.
Figure 5-5: Default screen layout
You can place additional objects on the build tray by repeating this
procedure.
The Extents values displayed at the bottom of the dialog box represent the
maximum dimensions of the object on each axis. These dimensions
correspond to the virtual “bounding box” surrounding the object (see
Hierarchy
pane
Build tray
Object
properties