Objet Objet30 User Manual - page 132
Operating & Maintaining the Objet30 3-D Printer
7–52
DOC-24000 Rev. C
10. Inspect the new lamp reflector, and make sure that a black strip is
attached to the inside of it. If not, install one—on the side of the
reflector opposite (not next to) the print block.
Note: Extra black strips are included in the printer Start-up Kit. If
necessary, you can remove the black strip from the old reflector and install
it in the new reflector (as long as the black paint has not faded).
11. Discard the old reflector and lamp.
12. Insert the new UV lamp/reflector unit into the housing.
13. Make sure that the UV‐lamp cable is in place, inside the housing, and
then tighten the securing screws.
Figure 7-77: Cable position when installing the UV lamp
14. Replace the lamp cover, and tighten the securing screws.
15. Replace the UV lamp assembly in the printer, making sure that the
cable fits into the slot together with the side securing screw.
Figure 7-78: UV-lamp cable after replacing the assembly
16. Tighten the two side securing screws.
17. Reconnect the power connections (see figure 7‐72).
Dispose of the used UV lamp in accordance with environmental and safety
requirements.