Objet Objet30 User Manual - page 85

DOC-24000 Rev. C

7–5

Objet30 User Guide

4. Check the Objet30 printer interface to make sure that the new cartridge 

is detected and that its weight is displayed (see figure 7‐3).

5. Close the printing‐materials drawer.

Tips about replacing cartridges:

•

You can replace material cartridges either before or during printing. If 

you do so while printing, make sure to load the new cartridge and close 

the cartridge drawer within three minutes. This ensures that the print job 

is not interrupted. (When the drawer is open, the cartridges are not 

displayed in the printer interface.)

•

If printing stops for an extended time before you replace a material 

cartridge, the printer may go into Standby or Idle mode. If this happens, 

see “Resuming Production After Printing has Stopped” on page 9.

•

You can replace partially used cartridges to avoid the need for replacing 

them during printing. However, repeated removal and installation of a 

cartridge may cause the material in it to leak. Therefore, it is 

recommended that you limit the re-installation of used cartridges.

•

You can load partially used cartridges, as long as they contain more 

than 100 grams of material.