Objet Objet30 User Manual - page 135
Manual is about: 3-D Printer System
of
142
DOC-24000 Rev. C
7–55
Objet30 User Guide
To replace the waste container:
1. Open the materials drawer.
2. Remove the fireproof cover from the waste container.
Figure 7-82: Removing the waste-container cover
3. Unscrew the cap securing the waste drain tube.
4. Carefully lift out the waste container to remove it from the printer.
5. Close the full container with a sealing cap.
6. Place the new waste container in the materials drawer, and attach the
drain tube to it.
While attaching the cap with the waste drain tube, hold the waste bag
stationary.
7. Close the new waste‐container box.
Figure 7-83: Waste container with drain tube attached