Objet Objet30 User Manual - page 93
DOC-24000 Rev. C
7–13
Objet30 User Guide
•
High‐performance. During this cycle, which takes about 60 minutes,
the wizard cleans the feed tubes and print block more thoroughly
by flushing the system with more material.
This cycle ensures that models will have the color (and the
mechanical properties) of the new material, when replacing a dark‐
colored material (such as VeroBlack) with a lighter‐colored material.
The amount of material flushed during this cycle is:
300 grams (± 10%) when replacing one cartridge
450 grams (± 10%) when replacing two cartridges
7. Click
Next
, and take note of the warning screen.
Figure 7-14: Material Replacement warning screen
8. To continue, click
Next
.
9. When prompted by the wizard screen, remove the material cartridges.
Select the check box to confirm that you have done so, and click
Next
.
Figure 7-15: Remove Cartridge confirmation screen
Once you start this procedure, you must complete it before you can produce
models with the Objet30 printer. To perform the procedure at another time,
click Cancel. If you continue (by clicking Next) and you do not complete the
procedure, you must start the Material Replacement wizard again before
producing models.