Objet Objet30 User Manual - page 79
DOC-24000 Rev. C
6–11
Objet30 User Guide
User Alerts
Job Manager can alert you and others to the status of the jobs sent to the
server for printing. This is especially useful during long printing jobs, when
the operator is away from the 3‐D printer. The following events can be
reported:
•
The level of model or support material is low.
•
The job was interrupted.
•
The job was completed successfully.
For details on how to configure alert messages, see “Configuring User
To set parameters for “Low level of material” alerts:
1. From the 3‐D Printer menu, select
Material Consumption….
2. In the dialog box that opens, set the time or the material weight
remaining that triggers the alert message.
Figure 6-8: Material alert message dialog box
The dialog box shown above also pops up over the Job Manager screen to
alert the operator that there is not enough material loaded in the printer to
complete the current job. As long as this condition exists, a warning icon
appears in the lower‐right corner of the Job Manager screen (when the
status bar is visible).
Note: If the status bar is not visible, select it from the View menu.