Objet Objet30 User Manual - page 92
Operating & Maintaining the Objet30 3-D Printer
7–12
DOC-24000 Rev. C
5. From the drop‐down menu, choose the material you want to install,
and click
Next
.
Figure 7-12: Material
Selection screen
Note: This selection automatically affects the default material setting in
Objet Studio.
6. In the Flushing Options screen, choose the appropriate cycle for the
model material you want to install.
Figure 7-13: Flushing Options screen
•
Economy. During this cycle, which takes about 25 minutes, the
pump purges the model material from the print block, then flushes
the system with the new material.
Since traces of the previous material may be present in the first
models printed with the new material, this cycle is usually
acceptable when replacing a light‐colored model material with a
darker material (such as VeroBlack™), or if the exact color of the
printed models is unimportant. However, this cycle ensures that
models will have the mechanical properties of the new material.
The amount of material flushed during this cycle is:
65 grams (± 10%) when replacing one cartridge
110 grams (± 10%) when replacing two cartridges