Objet Objet30 User Manual - page 82
Manual is about: 3-D Printer System
of
142
Operating & Maintaining the Objet30 3-D Printer
7–2
DOC-24000 Rev. C
Figure 7-1: The Objet30 3-D Printer
Starting the Objet30 Printer
1. Turn on the main power switch, located at the back of the Objet30
printer.
Figure 7-2: Main power cable and switch
The main power switch turns on the Objet30 printer, which includes
the built‐in Objet30 computer.
Printer cover
Printing-materials &
waste compartment
Printer stand
CAUTION!
•
Do not attempt to operate the Objet30 printer before being trained by
an Objet customer-support representative.
•
Observe all safety warnings and follow the safety guidelines described
in chapter 2.