Objet Objet30 User Manual - page 117
Manual is about: 3-D Printer System
of
142
DOC-24000 Rev. C
7–37
Objet30 User Guide
When the print block is completely drained, the wizard wipes the
heads. Then, the following warning screen appears.
Figure 7-52: Head Replacement warning screen
6. Click
Next
if you are ready to continue.
7. Open the Single Head Replacement kit, and remove the safety gloves
and the instructions.
8. Put on the safety gloves.
9. When the following screen is displayed, open the Objet30 printer
cover.
Note: The Objet30 printer disconnects power to the heads for your safety.
Figure 7-53: Replace the defective head when this screen appears