Objet Objet30 User Manual - page 136
Operating & Maintaining the Objet30 3-D Printer
7–56
DOC-24000 Rev. C
8. Place the fireproof cover over the waste container, making sure that the
drain tube is free and not bent.
Figure 7-84: Fireproof cover installed over the waste container
Note: Operating the printer without the waste-container cover results in an
inaccurate measurement of the waste weight, which will cause waste to
overflow into the printer.
9. Close the materials drawer.
Cleaning the
Exterior Panels
The painted exterior plastic panels of Objet30 3‐D printers have a durable
finish, offering excellent chemical resistance to common cleaning agents.
However, follow the recommendations below when cleaning these areas of
the printer.
Acceptable Cleaning Agents
•
mild soap solution
•
common household cleaners and window cleaners
•
common commercial and industrial detergents, 5% solution in water
•
alcohol (ethanol, isopropanol), 10% to 40% solution in water
Wipe the exterior of the printer, using a soft cloth moistened with the
cleaning solution.
Unacceptable Materials
•
industrial solvents
•
cleaning agents containing hydrocarbons, ketones, esters and lacquer
thinners
•
spray disinfectants
•
abrasives and agents which could wear away the panel finish
Dispose of the full waste container in accordance with environmental and
safety requirements.