Objet Objet30 User Manual - page 47
DOC-24000 Rev. C
5–13
Objet30 User Guide
Figure 5-16: Object properties dialog box, Transform tab
You can make precise changes to an object on the build tray by selecting the
object (either on the tray or in the tray hierarchy pane), changing its values
in the dialog box, and clicking
Change Units
.
Note: You can only change the height of the objects on the build tray if this
is allowed by the Objet Studio settings (see “Object Position on the
The properties displayed in the Transform tab of the object properties dialog
box are absolute values, representing the actual position of the object on the
build tray. Another way of repositioning objects on the tray using precise
values is by applying changes to object properties relative to the current
position. There are two Relative Transform dialog boxes available:
•
The R. Trans tab of the object properties dialog box.
Figure 5-17: Object properties dialog box, R. Trans tab
•
The Relative Transform dialog box, accessible from the Object menu.
Figure 5-18: Relative Transform dialog box