Objet Objet30 User Manual - page 112
Operating & Maintaining the Objet30 3-D Printer
7–32
DOC-24000 Rev. C
7. In the wizard screen, select the check box to confirm that the
transparency sheet is on the build tray, and click
Next
.
The Objet30 printer prints the head alignment test on the transparency.
8. When the following screen appears, remove the transparency.
Figure 7-45: Head Alignment wizard—steps 8–10
The transparency sheet is printed with sets of vertical lines in two rows,
each showing the results from a different print head.
Figure 7-46: Sample head-alignment test
•
The top row was printed by the head used for applying model
material when producing models.
•
The bottom row was printed by the head used for applying support
material.
9. Use a magnifying glass or loupe to inspect the transparency.
Optimum head alignment is shown when the two #8 lines, in the upper
and lower rows, are aligned, as in figure 7‐46. In the example shown, no
change to the head alignment is necessary. If other lines in the set are
aligned, you need to change the alignment—in the next wizard screen.
10. In the wizard screen shown in figure 7‐45, select the Transparency
removed check box, and click
Next
.
Model head
Support head