Objet Objet30 User Manual - page 128
Manual is about: 3-D Printer System
of
142
Operating & Maintaining the Objet30 3-D Printer
7–48
DOC-24000 Rev. C
Replacing the
Odor Filter
The Objet30 printer has an activated‐carbon filter for removing odors from
printing materials. The filter should be replaced regularly (about once a
year, as necessary) to keep your working environment pleasant. This is
normally done during the yearly preventive‐maintenance service visit.
To replace the odor filter:
1. Locate the filter drawer at the rear of the printer and pull it open.
Figure 7-68: Rear of the Objet30 printer
2. Remove the used filter. (You can push it out from underneath the
drawer.)
Figure 7-69: Odor filter in drawer
3. Insert a new filter and close the drawer.
Odor filter drawer