Objet Objet30 User Manual - page 109
Manual is about: 3-D Printer System
of
142
DOC-24000 Rev. C
7–29
Objet30 User Guide
3. When the following screen appears, open the cover.
Figure 7-41: Wizard screen that appears when you can begin the procedure
4. Loosen the two side screws securing the UV lamp assembly, and
remove the assembly.
Figure 7-42: UV-lamp-assembly securing screws
5. Move the print block all the way to the front of the printer, exposing
the roller‐waste‐collector locking pin.
Figure 7-43: Roller-waste-collector locking pin
WARNING: The print head orifice plates (bottom surface) may be hot.
Do not touch them with your bare hands, and proceed with caution.
Securing
screws