Objet Objet30 User Manual - page 14
Safety
2–2
DOC-24000 Rev. C
Safety Features
Objet30 3‐D printers are designed to comply with CE and FCC standards.
They are equipped with the following safety features:
Figure 2-1: Front and back views of the Objet30 printer
Cover interlock
switch
The power supplied to the UV lamp and the
motion motors is turned off when the cover is
opened.
WARNING: Do not defeat (override) the
interlock switch. Doing so could result in
serious personal injury. If the interlock switch
does not function correctly, do not use the
printer, and contact your service provider.
Cover lock
The cover is locked while the printer is
working. It is released when the printer reverts
to pause or stop mode.
WARNING: Do not defeat (override) the
safety lock. Doing so could result in serious
personal injury. If the safety lock does not
function correctly, do not use the printer, and
contact your service provider.
UV screen
The transparent section of the cover blocks
harmful UV radiation, allowing the operator to
view the model as it is being made.
Circuit breaker
The power to the printer is turned off in case of
electrical overcurrent.
Note: The circuit breaker is only accessible to
service personnel.
Grounded chassis
The chassis of the printer is grounded, to
prevent electrical shock.
Note: The power outlet must be properly
grounded, in accordance with the local
electric code, to provide this protection.
UV screen
Cover interlock switch
Circuit breaker
If the Objet30 3-D printing system is not used as specified in this guide, the
safety features may not provide adequate protection.