Objet Objet30 User Manual - page 108
Operating & Maintaining the Objet30 3-D Printer
7–28
DOC-24000 Rev. C
12. Select the confirmation check boxes in the wizard screen and click
Next
.
Figure 7-39: Wiper Cleaning procedure—final confirmation screen
13. Click
Done
to close the wizard.
Cleaning and
Replacing the
Roller Waste
Collector
Normally, you do not have to inspect and clean the roller waste collector.
This is done by a customer‐support engineer during regular maintenance
visits. Occasionally, however, a blockage or damaged scraper may cause
material leakage on the build tray. If this happens, remove the roller waste
collector and replace it.
To remove the roller waste collector:
1. From the Options menu, select
Wizards
>
Heads Cleaning
.
This wizard prepares the printer for removing the roller waste
collector.
2. When the following screen appears, confirm that the tray is empty and
that the printer cover is closed, then click
Next
.
Figure 7-40: Wizard confirmation screen
The print block moves to the center of build tray, and the tray lowers.