Objet Objet30 User Manual - page 30
Installing Objet Software
4–2
DOC-24000 Rev. C
How to Install Software for the Objet30 3-D Printing System
The Objet Studio setup wizard guides you when installing the Objet
software. During installation, you must choose to install either the server
(“host”) application or the client application.
To install Objet software:
1. Insert the Objet Studio CD into the disk drive.
2. Right‐click the
Start
button and select
Explore
(or use any other method
for displaying files on the computer).
3. Open the CD‐drive folder and select
Setup
.
To run the installation wizard, you must accept the Objet Studio license
agreement. After reading its terms, click
Yes
to continue, or
No
to close
the wizard.
If you click
Yes
, the following screen should appear.
Figure 4-1:Objet Setup—installation wizard Welcome screen
4. Click
Next
to begin installation.
Figure 4-2: Objet Setup—Select Components screen