Objet Objet30 User Manual - page 111
DOC-24000 Rev. C
7–31
Objet30 User Guide
Aligning the
Print Heads
You should check the alignment of the print heads—
•
once a month
•
if model quality is not acceptable even after cleaning the orifice plate on
the bottom of the print block (see “Cleaning the Print Heads” on
The head‐alignment procedure takes about 20 minutes.
To check the alignment of the print heads:
1. Prepare—
•
a transparency sheet, at least 10 × 16 centimeters in size (4.5 × 6.5
inches)—about one‐quarter of the standard A‐4 or Letter size
•
any type of sticky tape, to fasten the transparency sheet to the build
tray
2. Start the Head Alignment wizard, from the Objet30 Options menu (see
3. Click
Next
to begin, and close the cover.
4. In the wizard screen, select the check box to confirm that the cover is
closed, and click
Next
.
Figure 7-43: Door is closed confirmation screen
5. When instructed to do so, place the transparency on the build tray—
near the left and rear edges of the tray, as shown in the following
figure.
Figure 7-44: Positioning the transparency on the build tray
6. Make sure that the transparency sheet is lying flat, and tape it to the
tray.