Quickie Q2 Lite Construction Manual - page 101
.....
At the leading edge of the templates, another piece of 1/4"
thick white foam is fitted vertically until it meets the first piece
of white foam; it too is attached with 5-MIN dabs. Round the joint
slightly where the two pieces of foam meet. Next, laminate 2 BID on
the outside of the foam oriented 45 degrees to the trailing edge of
the white foam. After allowing the lamination to cure, the next step
is to remove the Fuel Tank Profile Templates, turn the foam over, and
glass 1 BID at 45 degrees on the inside foam surface. Be careful that
the main fuel tank doesn't warp and change shape during this process.
If you have trouble with waves in the center of the tank, additional
Fuel Tank Profile Templates may be used; if the hot forming operation
does not go well, you may cut-and-join several straight line
segments. Of course, the easiest way to build the Q2 main fuel tank
is to buy it prefabricated from Quickie Aircraft Corporation or one
of its dealers.
COCKPIT CONSOLE PIECE CONSTRUCTION
.....
Many pieces go into assembling the center and side consoles on
your Q2. You will make the individual pieces now, and then assemble
them to the fuselage in Chapter 14. Full-size templates are provided