Quickie Q2 Lite Construction Manual - page 283
Other manuals for Q2 Lite:
Owner's Manual, Owner's Manual
of
299
.....
A fillet is also necessary between the inboard face of the
wheel pant and the outboard end of the elevator. Set the elevator
with the trailing edge approximately 4 degrees up. Use scrap foam and
1 BID to create a fillet similar to the one shown in the picture.
ELEVATOR INBOARD FILLETS
.....
At the elevator/fuselage junction, a more complicated fillet
will improve performance. Since the junction angle is more than 90
degrees, you will want to sweep in a radius as shown using scrap foam
and 1 BID again. Visualize how the fillet will sweep into the
cowling.