Quickie Q2 Lite Construction Manual - page 36
Q2 Plans - Chapter 3 - Page 3-05
FLOX
.....
Flox is a mixture of cotton fiber (flocked cotton) and epoxy. The
mixture is used in structural joints and in areas where a very hard,
durable buildup is required. Flox is mixed much the same as dry micro,
but only about two parts flock to one part epoxy is required. Mix in just
enough flox to make the mixture stand up. If "wet flox" is called out,
mix it so it will sag or run.
.....
When using flox to bond a metal part be sure to sand the metal dull
with 220-grit sandpaper and paint pure mixed epoxy (no f10x) on the metal
part.
BONDO
.....
Throughout these plans the term "Bondo" is used as a general term
for automotive, polyester body filler. Bondo is used for holding jig
blocks in place and other temporary fastening jobs. We use it because it
hardens in a very short time and can be chipped or sanded off without
damaging the fiberglass. Bondo is usually a dull gray color until a
colored hardener is mixed with it. The color of the mixture is used to
judge how fast it will set. The more hardener you add, the brighter the
color of the mixture gets, and the faster it hardens. This simple guide