Quickie Q2 Lite Construction Manual - page 179
the top and bottom surfaces of the canard to the sun, changing the angle
of the canard periodically to heat the entire surface. Check the
temperature frequently by placing the palm of your hand on several
locations. If you can hold your hand on the surface for about 5 seconds
without screaming out in pain, the temperature is perfect. Permit the
canard to set at that temperature for about 10 minutes. DO NOT PERMIT
THE CANARD TO GET TOO HOT.
.....
It is not necessary to post-cure any other structure on your
aircraft.
END OF CHAPTER
PAGE 10-10
Q2 Plans - Chapter 11 - Page 11-01
WHEEL PANT/TIRE/WHEEL/BRAKE ASSEMBLY
INTRODUCTION
.....
In this chapter, you will make one left wheel pant and one right
wheel pant, complete with wheel, tire, and brake assemblies.
.....
The wheel pants are composite structural shapes that must transfer
all landing gear loads into the canard. Therefore, they are made much
stronger than the ordinary cosmetic type wheel pants found on many
homebuilts. There is some carving required, but you would find it
straight forward.