Quickie Q2 Lite Construction Manual - page 184
1.
LG4 should remain .250" thick at the axle hole.
2.
A smaller pant will be lighter and cleaner
looking, so don't leave excess foam on the pant.
3.
The top canard skin will be sanded back for 5"-8"
to provide a pleasing, curvaceous contour.
.....
After the wheel pant is carved, you are ready to glass the wheel
pant. Layup two BID over the outside face of the canard. Lap up onto the
canard a minimum of 1.5" inboard of the contouring, and use a minimum of
1" overlap wherever else you overlap the cloth. After this layup has
cured, remove the lumber jigging from the inside face of the wheel pant,
roughup the inside face contouring if needed, and then glass two BID on
the inside face.
.....
Also, another flagged UNI stiffener will have to be laid up on each
LG4, using the same technique as you did earlier.
.....
Check the sketches carefully and verify that your construction
agrees; wheel pants falling off your aircraft are bad form.