Quickie Q2 Lite Construction Manual - page 153
5.
When the complete aileron assembly fits well, and
rotates freely, mix up some 5-MIN with flox and
temporarily mount CSIO, CS6, and CS7 in place
against the main wing shear web, again checking
for alignment, clearances, and binding.
6.
If you haven't already done so, repeat for the
other aileron.
7.
Remove all of the pieces except CS10, CS6, and
CS7. Carefully lay up the BID cloth that
permanently holds CS10, CS6, and CS7 in place.
These parts must be solidly mounted so that they
cannot be accidentally broken off while in
service.
8.
Once the laminations in step 7 have cured, you are
ready to drill in the aileron assemblies. Find
your aileron rigging template, reassemble
everything and set the ailerons at 0 degrees.
Also, the "ear" on each A2CSA4 should point
forward and be parallel to a WL. Verify that the
aileron is pushed outboard against CS10. Verify
that CSll overlaps 1.0" into A2CSA4 and 1.8" into
the aileron reducer. Now drill in very carefully
the two bolts on each side that fasten Q2CSA4,
CSll, and CS9/aileron reducer together. BE
CAREFUL! Don't let the holes elongate; use a small
drill and work up in size.