Quickie Q2 Lite Construction Manual - page 278
PITOT-STATIC SYSTEM INSTALLATION
.....
Begin by mounting the two Q2PS1 static ports on either side of
the fuselage as shown. Use flox, being careful not to clog up the
static hole. Two static ports are used in order to assure accurate
readings during sideslip maneuvers.
.....
The schematic indicates the required connections for the Airspeed
and Altimeter. Run the tubing so that it does not interfere with
baggage or passengers. It is recommended that it travel down the center
console before reaching the instruments.
.....
The pitot system must be leak checked. Have one individual watch
the airspeed indicator, while the other person blows into the pitot
tube and uses his tongue to hold in the pressure. The airspeed
indicator should register a speed, which remains constant for a few
seconds. If the speed diminishes while the second individual is holding
the pressure in the system, then there is a leak somewhere, probably at
one of the connections.