Quickie Q2 Lite Construction Manual - page 111
Other manuals for Q2 Lite:
Owner's Manual, Owner's Manual
of
299
PAGE 5-3
Q2 Plans - Chapter 5 - Page 5-04
VERTICAL FIN
.....
The vertical fin is cut out of the remains of the piece that you
used to make the canard center section core. (Remember, the one we told
you to keep and not throwaway). The sketch is self-explanatory.
RUDDER AND VERTICAL FIN TRAILING EDGE
.....
These two cores are made from the piece marked 'save' that was left
over after hot-wiring the main wing, BL50-100 cores. The stagger shown on