Quickie Q2 Lite Construction Manual - page 148
OUTBOARD AILERON PIVOT ASSEMBLY
.....
These instructions cover only the assembly of the left outboard
aileron pivot, but the right outboard aileron pivot is a mirror image,
and may be accomplished at the same time.
.....
First, find a QCSM7 pivot and position it about 0.25" inboard of
the outboard end of the aileron using 3 MSP43 cherry rivets spaced
radically at least 0.4" apart.
.....
Find CS10, and insert a QCSM5 stud as shown with the 3 washers and
the 2 AN363-428 nuts. There must be a minimum of 0.6" from the AN960-4
washer inboard to the end of the QCSM5 stud. This is to require the
aileron to be moved inboard at least 1/4" before it II falls off" the
QCSM5 stud for disassembly. Finally, round the end of the QCSM5 stud
slightly to assist in mounting the aileron.
.....
The sketch shows the outboard aileron pivot assembly as it will
look later when installed on the main wing shear web. Although not
shown, at that time, the aileron slot foam core and aileron trailing
edge foam core will be trimmed so that CS10 will fit flush against the
main wing shear web.