Quickie Q2 Lite Construction Manual - page 93
.....
Knife trim the edges. After 12-hour cure, sand the edges with
100-grit sandpaper as required for smoothness and good appearance.
.....
It may at this time seem a bit ridiculous to use three layups,
about four hours work, and two days cure, just to make a book end!
But remember, this book end was not designed for ease of
construction; it was designed instead, to let you get a first hand
exposure to the following operations before starting on your
airplane; glass cutting, foam preparation (slurry), BID and UNI
layups, flat surfaces, corners, and compound curves, flox corner,
knife trim, concave and convex foam carving, glass to glass surface
preparation, and sanding edges. So, use this experience to your best
benefit and spend the curing time studying the plans. Even if you're
experienced in glass layups, the book end is a worthwhile project to
get familiar with the workability of this BID and UNI weave cloth
PAGE 3-22
Q2 Plans - Chapter 3 - Page 3-23
EDUCATION SUPPLEMENT
Rip this page out of your plans and staple it to the wall of your
shop. While it is a handy reference, it's still a good idea to read
all the words in the education chapter once in awhile. Don't skip the
details - they're all important.
BASIC LAYUP PROCEDURE
1.
PREPARATION
: Ply 9 or gloves on hands, shop temperature 75° +
10°.