Quickie Q2 Lite Construction Manual - page 85

.....

The second practice layup is one intended to give you confidence 

in the strength of your work. This layup is a sample of composite 

sandwich structure and is typical of the load carrying structures in 

your Q2. When this layup is finished, and completely cured, you will 

subject it to a simple load test, and thus demonstrate the strength 

of your workmanship.

.....

First, tape a piece of waxed paper about 30 inches long to the 

top of your work table. Shape a piece of green foam as shown. 

.....

Go to your glass cutting area and cut the glass plies shown.

.....

Lay up two plies of UNI, two plies of BID, paint the foam with 

micro slurry, and press it in the center. Then lay up the other BID 

and UNI plies. Be careful to work a11.air bubbles out of the corners. 

The best way is to stipple with the brush. The glass is oversized so 

that it can be trimmed to exact dimensions later. Trim to the 

dimensions shown after curing 24 hours, using a coping saw or band 

saw. Allow the piece to cure for four days at room temperature before 

the load test.