Quickie Q2 Lite Construction Manual - page 90
.....
Mix Safe-T-Pox, make a small batch of slurry, and save the
remaining epoxy. Slurry the foam surface and apply two plies of BID
to the contoured surface. Start the layup in the center and work out
toward the edges. If you have trouble getting the glass into the
depression corners without bubbles, lift the plies and wipe in a
little dry micro. You will then find that it will lay smoothly in
without voids (see sketch). This depression is sharper than any in
your airplane and is intended to give you a feeling of how sharply
you can form the cloth.
.....
Before laying the third BID ply down, place your favorite photo
in the depression, and then lay the third BID ply over it. Scissor
trim the excess glass cloth. Allow to cure and knife trim the edges.
The lower edge is trimmed flush with the bottom of the foam block.