Quickie Q2 Lite Construction Manual - page 141
wing, so make the main wing cores as perfect as you know how. And, oh
yes, RE-RE-RECHECK THE MAIN WING TIP LEVEL LINES. If you are not
proud of everything that you have accomplished on the main wing so
far, don't go on to the next step until you are.
LAMINATING THE BOTTOM SKIN AND BOTTOM SPAR CAPS
.....
Study the two sketches labeled "Bottom Main Wing Lamination"
and "Top Main Wing Lamination" very carefully.
.....
Today, you will only be doing the "Bottom Main Wing Lamination",
but that one is enough, and will take 3 individuals about 2.5 hours
to complete. (The third individual mixes epoxy while the other two do
the lamination).
.....
To summarize the lamination, first you will laminate the wing
skin, which is 2 plies of UNI at 45 degrees to the main wing T.E.,
and then you will laminate spar caps A thru F. Begin by getting your
shop organized for a big layup. Next, cut the UNI for the main wing
skins as indicated on the sketch, labeling each one so that you will
know where it goes.
.....
Once you start this lamination, you will have to continue it
until you finish, so if you want lunch, a cup of coffee, or a nap,
now is the time to do it.
CONTINUED ON NEXT PAGE
PAGE 9-3
Q2 Plans - Chapter 9 - Page 9-04
.....
The first UNI ply is put on at 45 degrees to the main wing
T.E.. The fibers must be straight, so take your time getting the