Quickie Q2 Lite Construction Manual - page 96
7.
PRELIMINARY CONTOUR FILL
: Save sanding by troweling dry micro
over low areas while the glass layup is still tacky. This is
done at trailing edges, spar caps, or 'over any low areas. The
low places are overfilled with micro then sanded smooth after
full cure.
8.
KNIFE TRIM
: Save work of sawing and sanding edges by razor
trimming the edges at the "knife trim stage," which is about 3-4
hours after the layup.
9.
GENERAL INSPECTION
: Take a good look for dry glass, excess
resin, bubbles, and delamination before walking away from your
wet layup.
10.
CLEANUP
: If you've used Ply 9 skin barrier, you can get all
epoxy off your hands with soap and water. Epocleanse is also
excellent for removing epoxy and it returns natural skin oils.
Brushes - rinse twice in MEK and wash with soap and water.
Throwaway after two to four uses.