Quickie Q2 Lite Construction Manual - page 112

the front view is necessary because the rudder core is 27" long, while 

the remaining trailing edge length is only about 13". It is suggested 

that you cut the rudder core first, and then reduce the block length to 

13" for the trailing edge core. As a note of explanation, the rudder 

extends up the vertical fin only part way. (Similar to the way that the 

aileron extends outboard on the main wing only part way). 

WHEEL PANT CORES

.....

 The wheel pant cores are cut out from the scrap pieces that you now 

have laying around. They needn't be hot-wired, except to obtain the 

proper thickness, but rather can be cut out by band saw or coping saw. 

MISCELLANE0US USES

.....

 The remaining scrap can be used for many miscellaneous purposes, 

such as supporting major components to avoid damage, soft sanding blocks, 

filets to clean up airflow, etc. use your imagination. 

END OF CHAPTER