Quickie Q2 Lite Construction Manual - page 189
.....
On the canard shear web at each wheel pant, there is another
AN210-1A pulley to change the direction of the brake cable so that the
cable will have a straight pull on the brake arm.
.....
Use a piece of 0.063" thick aluminum one inch square and drill a
hole in the center for an AN3 bolt, and then rivet a nut plate to the
aluminum so that the bolt can pass through the aluminum into the
nutplate. Assemble the pulley combination as shown. Next, trial fit the
assembly against the canard shear web, removing foam and the canard
shear web glass as necessary so that the cable will not be pulling off
at an angle. When satisfied, remove the pulley and bolt, protect the nut
plate hole with silicone, and mount the aluminum/nut plate assembly to
the shear web with flox. Use 2 BID with a minimum of 111 overlap onto
the canard shear web to secure the aluminum/nut plate combination to the
shear web. Once the glass has cured, open up the hole and assemble the