Quickie Q2 Lite Construction Manual - page 120
rudder extends only partway up the vertical fin. Trial fit the
vertical fin trailing edge core against the vertical fin core where
the surgery had been performed. Note that the vertical fin trailing
edge core was hot-wired longer than necessary, and will have to be
trimmed to fit properly. When the cores are dry fit together, they
should make a smooth transition. If not, any depressions must be
filled with micro prior to glassing, and any bumps and joggles can be
sanded away. Join the vertical fin core- to the vertical fin trailing
edge core with micro slurry and a few dabs of 5-MIN to hold the two
together. Since the vertical fin is symmetrical, verify upon assembly
that the vertical fin trailing edge core is not attached cocked to
one side.
.....
Next, glass the vertical fin slot with 2 BID at 45 degrees to
the spanwise direction. This will be easier if you support the
vertical fin core vertically temporarily.
.....
Now, study the sketches and jig the vertical fin core to the
vertical fin female jigging templates with the 'tail' of the vertical
fin trailing edge core pointing down toward the jigging table. Make