Quickie Q2 Lite Construction Manual - page 143
point, just like you did on the aileron. Then, clean up your mess and
go celebrate your wizardry as a laminator. DON"T TOUCH THE MAIN WING
FOR AT LEAST 24 HOURS.
NOTE
.....
If you have room and can be patient, it would be better
to permit the bottom main wing lamination to cure for 48 hours
plus. In the meantime, you could skip ahead and perhaps do the
aileron slot foam core slot laminations. But, if your like
everyone else, you won't be able to resist making that jigging
table into a main wing for your Q2 as quickly as possible.
LAMINATING THE TOP SKIN AND TOP SPAR CAPS
.....
Build a framework out of scrap lumber and bon do to hold the
main wing jigged in place while you turn it over. As shown in the
pictures, we suggest that lumber run from tip to tip with a few cross
pieces. Don't get fancy, just tie everything together so that the
main wing won't move, (and, yes, we know the pictures show the
canard, but we forgot to take some of the main wing jigging).