Quickie Q2 Lite Construction Manual - page 170
OUTBOARD ELEVATOR PIVOT ASSEMBLY
.....
These instructions cover only the assembly of the left outboard
elevator pivot, but the right outboard elevator pivot is a mirror
image, and may be accomplished at the same time.
.....
First, review the MAIN WING chapter section on "Outboard aileron
Pivot Assembly". Except for the part number changes, you will be doing
exactly the same operations.
.....
Locate a QCSM7 pivot about 0.25" inboard of the outboard end of
the elevator using 3 MSP43 cherry rivets spaced radially at least 0.4"
apart. It will be necessary to "tunnel" through the elevator skin and
elevator foam core in order to reach the CS16 elevator torque tube for
riveting. The holes made by the tunneling operation should be filled
after riveting with dry micro.
.....
Find CS19, and insert a QCSM5 stud with the 2 AN970-4 washers, 1
AN960-4 washer, and 2 AN363-428 nuts, just as you did on the aileron
outboard 'pivot assembly. Remember, there must be a minimum of 0.6"
from the AN960-4 washer inboard to the end of the QCSM5 stud so that
the elevator must be moved inboard at least 1/4" before it "falls off"
the QCSM5 stud for disassembly. Finally, round the end of the QCSM5
stud slightly to assist in mounting the elevator.
.....
When the elevator is mounted, CS19 will fit flush against the
canard shear web. At that time, the 'outboard elevator slot foam core
will have to be trimmed to allow that.
MIDSPAN ELEVATOR PIVOT ASSEMBLY
.....
Read this section carefully before doing anything, and take the
time to visualize what the words are saying. Otherwise, you may find it
difficult to install or remove your elevators!
.....
These instructions will cover the left midspan elevator pivot assembly,
but the right midspan elevator pivot assembly is a mirror image.
.....
Find a QCSM3 stud and a QCSM2 pivot. Screw the QCSM3 stud into the
QCSM2 pivot, retaining it with AN363-1032 locknut, making sure that the
assembly is tight. Next, round the end of the QCSM3 stud slightly, as
shown, to facilitate installation and removal of the elevator later.