Quickie Q2 Lite Construction Manual - page 180
BASIC ASSEMBLY
.....
Begin by making two Wheel Pant cores (LGl) and four Wheel Pant
Covers (LG2). The procedures that follow cover assembling the left wheel
pant. Since the right wheel pant is a mirror image of the left wheel
pant, you will probably find it easy to assemble both wheel pants
simultaneously.
.....
Join LGI to LG2 with micro-slurry. The template sketch for LGI
shows the outline of LG2; basically, LG2 covers up the hole in LGI. You
may need to use some weight to hold LG2 to LGI until they are cured.
.....
Once the combination has cured, lay it face down on the table with
LG2 against the table. Laminate the plies shown in the sketch.
.....
Now, you are ready to flag the UNI stiffener over the future location
of the LG4 inserts. The stiffener location is shown on the LG2 template
drawing. 0 Begin with a piece of UNI cloth 14" x yu with the fiber
orientation along the 7" edge. Flag the piece 7 times along the yu edge
(i.e. every 2"). Flagging consists of the following procedure:
1.
Fold the cloth over on itself.
2.
Wet out the cloth.
3.
Lightly run a new razor blade across the bubble at
the edge.
4.
Stipple the cloth down.
5.
Repeat steps '1-4 as many times as needed.
(7 times)