Quickie Q2 Lite Construction Manual - page 219
TAILWHEEL INSTALLATION
.....
Once the tailspring has been installed in the fuselage
permanently, then you are ready to install the tailwheel.
.....
Locate the following parts: QTW3, QTW4, QTW5, QTWMl, and the
tailwheel. Insert the QTW4 spacer into the QTW3 weldment as shown. Trial
fit QTW5 to the QTW3 assembly with a AN3-2LA bolt. It may be necessary
to sand QTW3 in order to allow a small amount of vertical freeplay
between QTW3 and QTW5. Once all the parts fit together smoothly,
assemble as shown.
.....
Next, mount the tailwheel to the QTW5 fork as shown, using the
QTWMI axle and AN3-24A bolt.
.....
The next task is to mount the entire tailwheel assembly to the
tailspring. Start by leveling the fuselage laterally, and then trial fit
QTW3 onto the end of the tailspring. Trim the tailspring if necessary to
permit QTW3 to fit, or to obtain the nominal 7" length from the forward
edge of QTW3 to the fuselage. Drill in the single AN3-12A bolt holding
QTW3 to the tailspring after making sure that the vertical face of the
tailwheel is indeed vertical. (Otherwise the tailwheel will wear
unevenly). To mount the Tailwheel assembly permanently to the
tailspring, mix up some flox and obtain good squeeze out of the flox
upon assembly of QTW3 to the tailspring.