Cabletron Systems FRM User Manual - page 116
8-28
Frame Relay Module 4. 0 User G uide, Rev 01
To resolve any differences in addressing conventions, the backup path invokes a trans-
lation of the called and calling addresses. The FRM-compatible called and calling
addresses are translated into PDN-compatible called and calling addresses. Node 2 has
a translation template defined to intercept packets with the PDN-compatible calling
address for node 1. It translates these into the FRM-compatible calling address for
node 2. (The backup routing is transparent.)
To display existing translation templates, press
[A]
at the X.25 Address Translation
Templates Menu.
Figure 8-9 Address Translation Templates Display
[A],[C],[C],[A]
from Main Menu
The data between lines is structured to match the headings at the top of the
screen.
To add or change a translation template, press
[B]
at the X.25 Address Translation
Templates menu and enter:
●
RLP:
0–2
. (The default is
0
.)
●
Port
:
0–7
. (The default is
0
.)
●
Direction
:
I
(for incoming packets) or
O
(for outgoing packets). (The default is
I
.)
●
Template ID
: up to 31 characters (including the
G
and
U
separators described
below), in the format:
aaaaaaaaaaaaaGbbbbbbbbbbbbbbUddddddddddddddd
where:
aaaaaaaaaaaaaa
is up to 15 digits of called address,
G
is the letter "G," which precedes any calling address,
bbbbbbbbbbbbbb
is up to 15 digits of calling address,
U
is the letter "U," which precedes any user data, and
ddddddddddd
is a user data field of up to 12 numeric characters.
Node N ame= nod exyz
P D ir
Translation I D Trans lation Name
Calling
Called
User Data
Protocol ID
Facilities
=== == == === == === == == === == === == == === == == === == === == == === == === == == === ==
0
Incoming
3110*U*
tempexamp1
P
L1234
X 123
P
P
=== == == === == === == == === == === == == === == == === == === == == === == === == == === ==
0
Incoming
1233751* tempexamp2
L200C011009 P
P
01000000
P
=== == == === == === == == === == === == == === == == === == === == == === == === == == === ==
PgU p,PgDn , F3:Exit, F9:Stop Remote, F10:Abort: