Cabletron Systems FRM User Manual - page 304
20-4
Frame Relay Module 4. 0 User G uide, Rev 01
Configuring Port Statistics Thresholds
For each port statistic, you can specify a threshold that, when crossed, causes an alarm
to be sent to the collecting node.
Press
[A]
at the Statistics Menu. When prompted, enter:
●
Statistic level
:
P
for Port.
●
RLP
:
0
on FRM/2/3,
0–2
on FRM. (Default is
0
.)
●
Port
:
0–7
. (Default is
0
.)
A menu similar to the following figure will be displayed.
Figure 20-4 Port Statistics Configuration Menu
[E],[A]
from Main Menu
Changing a threshold changes the database value. Press
[F7]
to write the
change to system memory.
A threshold is either a number or a percentage, depending on the statistic. The valid
range for any statistic is
0–65535.
(Default =
0.
) When the measured value for the sta-
tistic crosses the threshold (in either direction), an alarm is generated.
Node N ame= node_xyz
Port Statistics (Th resh old s)
RLP: 0
Port: 1
Databas e
System Memory
A R eceived frames/Sec (*10)
0
0
B Trans mitted frames/Sec (*10)
0
0
C R etran frames/Sec (*10)
0
0
D FCS errors/Sec (*10)
0
0
E Logical rejects /S ec (*10)
0
0
F Trans mit error ratio
0
0
G R eceive error ratio
0
0
H % Receive port u tilization
0
0
I
% Tran smit p ort utilization
0
0
Option: