Cabletron Systems FRM User Manual - page 260
17-4
Frame Relay Module 4. 0 User G uide, Rev 01
E
Frame Relay Backup Status
– displays the current state of frame relay
primary and backup DLCIs.
A
Display States for all Backup DLCIs on a Port
B
Display States for all Primary DLCIs on a Port
C
Display States for all Backup DLCIs in a Group
F
LLC/2 Session Status
– displays addresses and operational states of all
current LLC2 sessions.
G IP Status Displays
A
IP Routing Table Display
– displays interfaces, destinations, network
masks, and flags.
B
IP ARP Table Display
– displays ARP IP addresses, MAC addresses, and
aging timers.
C
IP Interfaces Display
– displays interface names, MTU values, network
names, masks, IP and remote addresses, and flags.
D
Events
– (Chapter 21) Displays event (alarm) messages as they occur.
E Statistics
(Chapter 20)
A
Configure
RLP
/
Port
Thresholds
– allows creation of a threshold for a statistic
that, when crossed, will cause an alarm to be generated.
B
Display
RLP
/
Port
/
Frame
Statistics
– displays the supported statistics for the
specified component, showing current values, as well as the highest values
reached by each statistic since the node was last booted or since maximum
values were last cleared.
C
Display IP Statistics
– displays the supported statistics, including current values
and cumulative values since maximum values were last cleared.
D
Display ICMP Statistics
– displays the supported statistics, including current
values and cumulative values since maximum values were last cleared.
E
Display IP Interface Statistics
– displays the supported statistics, including
current values and cumulative values since maximum values were last
cleared.
F
Display IPX Interface Statistics
– displays the supported statistics, including
current values and cumulative values since maximum values were last
cleared.
G
Display LAN Card Interface Statistics
– displays the supported statistics,
including current values and cumulative values since maximum values
were last cleared.
H
Display Frame Relay Utilization Statistics
– displays CIR, B
C
, and B
E
values for
a specified DLCI, as well as the configured and actual percentages of
bandwidth use by each bandwidth allocation group.
F
Reports
A
Create Configuration Report
– (Chapter 3) produces a summary of all database
records in the node.
B
View Configuration Report
– (Chapter 3) displays the above summary.
C
View Initialization Report
– (Chapter 2) produces a list of messages created
during the current boot-up of a node.
D
View Previous Initialization Report
– (Chapter 2) produces a list of messages
created during the previous boot-up of a node.