Cabletron Systems FRM User Manual - Configuring Llc2
9-18
Frame Relay Module 4. 0 User G uide, Rev 01
Configuring LLC2
Configuring a Virtual LAN ID
A virtual LAN ID is normally assigned by a system administrator. The ID is used
internally by the FRM to identify a virtual bridge that connects the LLC2 function to
LAN interfaces.
If LLC2 will run in the local node, press
[B]
at the Configure IP/LLC2/BRIDGE/IPX
Default Parameters Menu
(or
[A], [A], [E], [B]
from the Main Menu). When prompted,
enter:
●
Virtual LAN ID:
0–fff
(hex). (The default is
000
.)
LAN IDs can also be configured in LLC2 Interface/Bridge
Port records (later in this chapter). Each Virtual LAN ID
must be unique among all LAN IDs throughout the network
on which this node will operate.
●
If also configuring Bridging in the node, address the remaining parameters as
described in
Chapter 15
. Otherwise, press
[Enter]
(accepting the default) for
each remaining parameter, since they are not used for LLC2.
Figure 9-5 LLC2 Defaults Configuration Screen
[A], [A],[E],[B
] from Main Menu
Only item A applies to LLC2. Leave the remaining parameters at their
default values.
N ode N ame= nodexyz
Configure Brid ge/LLC2 Nod e Defaults
A Virtual LAN I D
000
B Brid ge Enab led
N
C Brid ge Hello Time
2
D Brid ge Max Age
20
E Brid ge Forward Delay
15
F Brid ge Aging Timer (seconds )
300
G Brid ge Priority
0
H Max S ize Brid ge Forwarding Table
65535
I
IP Bridging Enabled
N
J
IPX Brid gin g Enab led
N
K SR B I D
0
L Default Eth ernet Frame Type
Typ e II
Op tion :