Cabletron Systems FRM User Manual - page 176
11-8
Frame Relay Module 4. 0 User G uide, Rev 01
Figure 11-3 Typical SVC Subscriber Screen
[A],[D],[B]
from Main Menu
Pressing
[G]
will display routing paths, which link the subscriber with one or more
ports. Pressing
[H]
will display the addresses used for call redirection. (These
addresses are valid only if
Y
is specified for one or more of items C, D, and E on the
first screen.) Parameters for all three screens are described following Table 11-2.
Subscriber Parameters
1
The software does not verify that the specified port exists. Make sure the specified ports
are configured in the database, and that they actually exist.
Subscriber Name
identifies the subscriber to the console operator. The FRM software does not use this
information.
Table 11-2 Subscriber Parameters
Parameter
Valid Values
Default Value
Subscriber Name
0–31 characters
none
Routi ng Al gori thm
0–3
0
System atic Redirection
Y/N
N
Redir ect on Busy
Y/N
N
Redir ect on O ut of Order
Y/N
N
Connection Priority
0–9
0
1st, 2nd, etc. Path Confi gured
Y/N
N
RLP
0–2
0
Port
Physical port:
0–7
1
Logical port:
8–63
1
0
Redir ection Address 0,1,etc.
valid address
none
Node N ame= nod exyz
SV C S ubs criber Maintenan ce
*
S ubs criber ID
0100012345
A S ubs criber Name
sub 1
B R outing A lgorithm
0, Roun d R obin
C S ystematic R ed irection
N
D R ed irect on Busy
N
E R ed irect on Ou t of Order
N
F C onnection Priority
0
G R outing Paths
H R ed irection Add ress es
Option: