Cabletron Systems FRM User Manual - page 297
St atus Displays
19-25
Point-to-point frame relay IP connections will display a
Netmask
of
255.255.255.255
, which is the default
Destination Mask
value for Host
IP routes. The
Network Mask
/
NetMask
configured on the IP interface
is used by RIP for route summarization.
Each entry is two lines on the screen, with the
Netmask
on the second line,
under the associated
Destination
.
ARP Table
To display a list of active ARP (Address Resolution Protocol) table entries, press
[B]
at the IP Status Displays Menu (or
[C], [F], [G], [B]
from the Main Menu).
Information in this Display:
●
IP Address
– Address of corresponding IP Interface.
●
MAC Address
– MAC address to which each IP address maps.
●
AgeOut Timer
– Time (in minutes) until the address will be removed from the
table if no traffic is received from that address. The address is added to the table
after the FRM sends an ARP request for an IP address and receives a MAC
address in response. The timer is reset if an IP frame is received from the either
the IP or MAC address.
If the screen is filled with information, you will be asked whether you want to display
more.
The ARP table does not include entries for devices that have no LAN inter-
faces.
IP Interfaces
To display a list of active IP interfaces, press
[C]
at the IP Status Displays Menu (or
[C], [F], [G], [C]
from the Main Menu).
Information in this Display:
●
Name
– identifier used in the IP Route Display. Each name is the interface
number preceded by the interface type, which is one of these:
fr
Frame relay
x
X.25
en
Ethernet
tr
Token Ring
lo
Loopback
The loopback interface is added by the FRM, and has a
number one greater than the highest configurable interface
number (to avoid a conflict)..
●
MTU
– Maximum Transmission Unit, the maximum size (in bytes) of the data
field that can be used to encapsulate an IP datagram for transmission over the
interface.
●
Network
– bit-wise AND of the
IP Address
and the
Mask
.
●
IP Address
– IP address of the local interface.
●
Rem Address
– IP address of the remote device.