Cabletron Systems FRM User Manual - Configuring Bridge Ports
15-12
Frame Relay Module 4. 0 User G uide, Rev 01
Filter "n"
corresponds to the Filter IDs in
Bridge Filter Definitions
.
Configuring Bridge Ports
A Bridge port is an FRM Ethernet interface or frame relay port that will operate as a
bridge connection to the LAN or WAN.
Press
[C]
at the IP/LLC2/BRIDGE/IPX Interfaces Configuration Menu to display con-
figured Bridge ports.
Figure 15-4 Bridge Ports Display
[A],[C],[E],[C]
from Main Menu
These interfaces can be used for either LLC2 or Bridging.
To configure an interface, press
[D]
at the IP/LLC2/BRIDGE/IPX Interfaces Config-
uration Menu. When prompted for an
Interface Number
(which is merely a sequential
number to identify the interface):
●
If modifying an existing record, enter the interface number:
0–95
.
Do not configure more than one interface per DLCI on a
port.
●
If creating a new record, press
[Enter]
, which will automatically specify the next
available sequential interface number.
Node N ame= node_xyz
Review Brid ge Ports/LLC2 In terfaces
-------------------------------------------------------------------------------------------------------
Interface Numb er
Type
RLP
Port
DLC I
Format
-------------------------------------------------------------------------------------------------------
0
Ethernet
1
Frame R elay
0
1
30
Native LLC-2
2
Frame R elay
0
1
31
8025_SRB
3
Frame R elay
0
1
32
8025_SRB
4
Frame R elay
0
1
33
8023_TB
PgU p, PgD n, F3:Exit, F9:Stop Remote, F10:Abort