Cabletron Systems FRM User Manual - page 202
13-4
Frame Relay Module 4. 0 User G uide, Rev 01
Figure 13-1 IP Node Defaults Menu
[A],[A],[E],[A]
from Main Menu
After changing the RIP version, press
[A], [C], [E], [G]
from the Main Menu, to update
the node with the change.
IP Node Defaults Parameters
RIP Version
determines the version of RIP that will be supported on the FRM.
RIPv1
and
RIPv2
are
incompatible with each other on the same network; however, each is compatible with
RIPv1 Compatibility
. If transitioning a network from RIP Version 1 to Version 2, recon-
figure each device to
RIPv1 Compatibility
, until all devices are configured for
RIPv1
Compatibility
. Each device can then be configured for
RIPv2.
Table 13-1 IP Defaults Parameters
Parameter
Valid Values
Default Value
RIP Version
RIPv1, RIPv2, RIPv1 Compatibility
RIPv1
N ode N ame= nodexyz
IP Node D efau lts Men u
A RI P Version N umber
R IPv1
Op tion :