Cabletron Systems FRM User Manual - page 259
Introduction to Syst em Operation
17-3
C
Restore the Backed-Up Database to a Remote FRX4000
– is not used on the
FRM.
D
Back up the Current Database to a Local Directory
E
Restore the Database from a Local Directory
F
Back Up the Current System Files to a Local Directory
G
Restore the System Files from a Local Directory
D
Test X.25 Address Translation Templates
– (Chapter 8) Tests templates to
assure they were correctly created.
E
Re-Load Initialization to Async Console
– (Chapter 18) Sends default terminal
settings to an Auxiliary Console on the node's COM1 port.
F
IP Ping Connectivity Test
– (Chapter 18) Uses the Ping function to determine
whether an IP host is reachable.
G On-Line SDLC PU Operations
(Chapter 9)
A
Disable an SDLC PU
– Takes any SDLC PU in the node off line.
B
Disable a Range of SDLC PUs
– Takes a group of PUs off line.
C
Enable an SDLC PU
– Brings any SDLC in the node on line.
D
Enable a Range of SDLC PUs
– Brings a group of PUs on line.
H
NetView Access
– (Appendix C) allows a NetView manager to obtain
information on the node via NMVT commands or from files in the node
database.
I
CSU/DSU Tests
– is not used on the FRM.
J
Frame Relay Backup Operations
– (Chapter 18) allows manual switching from
a primary frame relay DLCI to its backup, or from the backup to the primary.
A
Initiate Switching Primary DLCI Over to its Backup
B
Initiate Switching DLCI Back to the Primary
C
Status Displays
(Chapter 19)
A
Node Status
– displays performance and link status for the node.
B
Port Status
– displays port type, operational status, and link states for all ports
on the node.
C
Virtual Connections
– displays DLCIs/LCNs, link states, subscribers, and
(frame relay only) performance for all logical connections.
D
Port Signals
– displays configuration data for each port on a specified RLP, and
shows on/off status of each signal at the interface.
E Traffic Monitor
A
Port Monitor
– displays control and information data of all level-3 packets
passing through a specified port.
B
LAN Capture Status and Control Menu
– allows configuration of parameters
that identify LAN cards and specify information to be captured when
monitoring LAN traffic.
C
LAN Capture Review
– displays captured LAN monitor information.
F
Protocol Status
A
IPX RIP Table Display
– displays the contents of the RIP table.
B
IPX SAP Table Display
– displays the contents of the SAP table.
C
SDLC PU Status
– displays a list of configured station addresses for a
specified SNA port, including current active/inactive states.
D
Bridge Status Displays
A
Bridge Port Status Display
– displays a list of Bridge ports, including
type, active status, bridge state (forwarding, listening, etc.), and number
of bytes received and transmitted.
B
Bridge Forwarding Table Display
– displays a list of MAC addresses and
their associated bridge ports, plus any flags that have been set.