Cabletron Systems FRM User Manual - page 184
12-6
Frame Relay Module 4. 0 User G uide, Rev 01
20, Echo Mask
allows selected sets of characters received from the user's device to avoid transmission
back to the start-stop mode DTE. Values (can be added) are:
0
=
no echo mask (all characters echoed).
1
=
no echo of CR.
2
=
no echo of LF.
4
=
no echo of VT, HT, FF.
8
=
no echo of BEL, BS.
16
=
no echo of ESC, ENQ.
32
=
no echo of ACK, NAK, STX, SOH, EOT, ETB, ETX.
64
=
no echo of editing characters as designated by parameters 16-18.
128
= no echo of all characters not mentioned above and DEL.
If parameter 5, 12, or 22 is set to anything other than
0
, X-ON and X-OFF are not
echoed. If parameter 2 is set to
0
, parameter 20 does not apply.
21, Parity
allows the PAD to check parity in the data stream from the user's device and/or to gen-
erate parity in the data stream to the user's device:
0
= no parity.
1
= parity checking.
2
= parity generation.
3
= checking and generation.
22, Page Wait
specifies the number of line feed characters that, when sent by the PAD to the DTE,
will start a Page Wait condition, suspending transmission of additional characters to
the user's device.
Configuring Async PAD Login Parameters
If an async subscriber will be required to log into an FRM async PAD, a login ID must
be assigned. To display a list of existing login IDs and associated PAD profile names,
press
[C]
at the Async PAD Configuration Menu (or
[A], [A], [F], [C]
from the Main
Menu).
To add or change login ID parameters, press
[D]
at the Async PAD Configuration
Menu and enter a
subscriber ID
(described on page 12-14).